Retroradio GenresGuidesWhat reaches you, and who licensed it

Guide · Station specs

HAAT and ERP Explained: Why Antenna Height Beats Power

By Justen Linker · Published · All guides

Every FM station page lists two numbers that decide how far it reaches: ERP, the power it radiates, and HAAT, how high its antenna stands above the land around it.

ERP: effective radiated power

A transmitter's output is not what reaches the air. The signal loses some power in the cable up the tower, and the antenna then concentrates what is left toward the horizon instead of wasting it on the sky and the ground. ERP — the transmitter power, less the cable loss, multiplied by the antenna's gain — is the power the station effectively sends toward you. It is what the FCC licenses, and what station pages here list.

A 25 kW transmitter feeding a gain-4 antenna gives roughly 100 kW ERP, the maximum for most of the country.

HAAT: height above average terrain

Height matters relative to the surrounding land, not to sea level. To calculate HAAT, the FCC averages the elevation of the ground along eight compass directions between 3 and 16 km (2 and 10 mi) from the tower, and subtracts that average from the height of the antenna's centre. A short tower on a mountaintop can have a HAAT of 600 m or more; a tall tower in a valley can come out negative.

On our pages HAAT is shown in both units — for example "981 ft (299 m)", the figure for KASH-FM.

Why height wins

FM signals travel in near-straight lines, so the horizon is the hard limit (see how FM coverage works). Raising an antenna pushes the horizon back; adding power mostly makes the signal stronger inside it. Roughly:

So a 6 kW station on a ridge 400 m above the plain can be heard further than a 50 kW station on a 50 m tower — the low station is loud close in, then hits its horizon and stops.

How the FCC trades one for the other

Each FM class has a reference maximum: Class A is 6 kW at 100 m, B1 and C3 25 kW at 100 m, B and C2 50 kW at 150 m, C1 100 kW at 299 m, C0 100 kW at 450 m and Class C 100 kW at 600 m. A station whose antenna is higher than its class allows must cut its power to keep the same coverage; one whose antenna is lower may not make up the difference with extra power. That is why you will see stations with odd-looking figures such as 2.3 kW at 160 m — they are matching the coverage of their class from an unusual site.

And AM?

AM works differently. The whole tower is the antenna, usually a quarter of a wavelength tall or more, and HAAT plays no part. AM reach depends on transmitter power, the conductivity of the ground and, at night, the ionosphere — which is why AM pages list day and night power instead. Our guide to AM at night explains the difference.

More guides

Spotted a mistake? Corrections are welcome at operator@the-retroradio.com.